Watch manual - ESMATI Ator

This manual contains essential guidance for setting, adjusting, and maintaining your Esmati Ator. We recommend reviewing it carefully to ensure optimal performance and long-term preservation.

Thank you for choosing ESMATI.

 

Setting the Date

STEP 1

Locate the crown on the right-hand side of the watch case, and pull it to the first position. You will feel a light click.

STEP 2

Rotate the crown slowly in a counterclockwise direction to change the date. When the correct date is set, gently push the crown back into its original position.

Setting the Time

STEP 1

Again, locate the crown and pull it out to the second position. You will feel a second, more distinct click.

STEP 2

Rotate the crown clockwise to adjust the hands to correct the time. Once the correct time is set, press the crown back into its original position.

Watch Band Link Removal Guide

To ensure your new watch fits comfortably, you can easily adjust the band by removing extra links. We’ve included a free link removal tool in your package to make this process simple and stress-free.

What You’ll Need:

• Your watch

• The free link removal tool (included)

• A soft cloth (to protect your watch)

• Optional: small pliers for pin removal

1. Lay Your Watch Flat

Place your watch face-down on a soft cloth or towel to prevent scratching.

2. Find the Removable Links

Look on the inside of the band. You’ll see small arrows on some links – these indicate the direction in which the pins should be pushed out.

3. Insert the Link Removal Tool

Line up the pointed tip of the tool with the small hole on the side of the link (on the side the arrow points away from).

4. Push the Pin Out

Gently twist the tool to push the pin out in the direction of the arrow. If the pin is tight, you can lightly tap the tool with your fingertip. As the pin slides out, you may use pliers or your fingers to pull it free.

5. Remove the Link

Once the pin is removed from both ends of the link, take the link out.

Repeat this step to remove more links if necessary.

6. Reconnect the Band

Align the loose ends of the band and insert one of the pins back (in the opposite direction of the arrow). Press or gently tap it in until it’s flush with the link.

7. Try It On

Put the watch on and check the fit. If it still feels loose, remove another link. If it’s too tight, you can always add a link back using the same process in reverse.

 Tips for Best Results

• For balance, remove links evenly from both sides of the clasp.

• Store any extra links and pins in case you want to adjust it later.

• If you’re unsure, any jeweler can assist.

Maintenance and cleaning

The battery in your quartz watch should be replaced approximately every 2 years by a qualified technician.

Clean the case and strap regularly using a soft, damp cloth. Avoid using soap, solvents, or abrasive materials. Dry thoroughly after exposure to moisture.